1, to establish the load of the anti-static floor with the net weight of the core machine equipment of all the machines and equipment in the main room as the standard, so as to prevent the permanent bending or damage of the calcium sulfate anti-static floor board caused by some machines and equipment too heavy.

2, the anti-static floor by the external ecological environment norms of the harm changes little. And it is not easy to have obvious expansion joints because the working temperature of the calcium sulfate anti-static floor is too high or too low, that is to say, when the temperature of the main room is slightly higher, the anti-static floor will expand and cannot be disassembled and replaced; When the temperature is low, anti-static calcium sulfate anti-static floor the electric floor shrinks, resulting in a loose feeling. Anti-calcium sulfate anti-static floor The shrinkage of the electrostatic floor under the influence of the environment should be less than 0.5mm, and the tensile strain of the surface should be less than 0.25mm.

3, the computer room infrastructure project needs to accurately cover the total area (or the number of pieces) of the anti-static floor and a variety of parts (standard preparation 1:3.5, 1:5.5), and empty the capacity to prevent consumption or urgent shortage.

Install the whole anti-static floor on the girder connected by the steel bars, calibrate the anti-static floor, its carrying capacity must be more than 1000kg/m2 symmetrical load, the centralized load in any area of the anti-static floor should exceed 300kg, at the loading point of 6cm in diameter, when the load of 300kg, the tensile strain should be less than 2mm. It's never been permanently bent. The adjustable fulcrum should be able to bear the vertical load on the basis of 1000kg anti-static floor, and the surface should have certain wear resistance. Electrical characteristics are usually system resistors, electrostatic voltages, and surface resistors. The system resistor should be 105-108, when the temperature is 211.5℃, the relative humidity of the air is 30%, the electrostatic voltage of the anti-static floor should not exceed 2500V, and the surface resistance value should be 105-108.

4, many calcium sulfate anti-static floor manufacturers produce and process the type and quality of anti-static floor, as well as a variety of technical parameters. Anti-calcium sulfate anti-static floor The technical features of the electrostatic floor refer to its physical and electrical properties. The physical properties are important and the bearing capacity and wear resistance are fully considered.

5, after the stainless steel plate through the process, the surface will show a completely different hue. At present, the surface of the stainless steel plate has long been successful to get a variety of colors such as brown, dark blue, light yellow and red. After treatment, the application of stainless steel plate in the decoration design industry will be more common.